[. . . ] With a combination of our love of music and the vast highend audio experience of the Technics team, we stand committed to building a brand that provides the ultimate emotive musical experience by music lovers, for music lovers. Director Michiko Ogawa 05 Thank you for purchasing this product. Please read these instructions carefully before using this product, and save this manual for future use. €¢ About descriptions in these operating instructions - Pages to be referred to are indicated as “ ○○”. [. . . ] When connecting an analogue audio output device, switch the input setting of this unit to “LINE2”. 19 Operations Using this unit as power amplifier You can connect the AV receiver, control amplifier, etc. With analogue audio cable (not supplied) to this unit and use this unit as power amplifier. Analogue audio cable (not supplied) Set the volume of the AV receiver, control amplifier, etc. While using this unit as power amplifier, the volume adjustment with this unit is disabled. Do not input the audio signal from PRE OUT/LINE OUT terminals to the MAIN IN terminals of this unit. €¢ You can also select the input source by turning the input selector knob on the unit. Note • It is not possible to adjust the volume with this unit. €¢ Sound is not output from headphones jack and PRE OUT terminals. €¢ Select “LINE2” when not using this unit as power amplifier. ( 19) • When the input source is switched to “LINE2” or other source from “MAIN IN” and the current volume level is higher than previous level, the volume is automatically adjusted. €¢ Not available when using this unit as power amplifier ( 20). 24 (24) Auto off function “AUTO OFF” This unit is designed to conserve its power consumption and save energy. The unit has been left unused for about 20 minutes and will enter standby mode within a minute. €¢ “AUTO OFF” is displayed 3 minutes before this unit is turned off. Note • The setting is stored even if the power is turned off and on. Displaying the volume status “VOLUME Display” The volume status is displayed when adjusting the volume. €¢ Not available when “MAIN IN” is selected as input source of this unit. Checking the firmware version “F/W Version” The version of the installed firmware is displayed. Settings (25) 25 English Settings Using output correction function (LAPC) You can make the optimum adjustment according to your own speakers. Measuring the output signal of the amplifier and correcting its output (LAPC) ■ Preparation • Disconnect the headphones. Test tone emitted during measurement To ensure the measurement accuracy, the speakers output a test tone at regular intervals. [. . . ] €¢ Sound is not output from headphones jack and speaker output terminals when the headphones are connected and “MAIN IN” is selected as input source of this unit. ( 20) “Remote ” (“ ” stands for a number. ) • The remote control and this unit are using different modes. ( 13) Signal Overflow • The sound from the analogue audio input terminals in use is distorted. [. . . ]